Start the installation

Connect your server to your network and insert the m23 server installation CD in the bootable CDRom drive of your server. Hold the network settings ready. The installation procedure is mostly self-explanatory and should not be a problem for anybody who is familiar with the administration of networks. On the next pages you can see screenshots of the installation procedure. Don't worry if there are less screenshots than screens in the real installation procedure because it doesn't make sense to show every status message ;).

Image inst1
This is the boot screen of the m23 server installation CD. Press Enter to boot the Linux operating system from the CD. Afterwards, the installation programm will be started.

Image inst2
You have to choose if you want the messages of the installation program in German or in English. We assume you select ''English''.

Image inst3
Just saying ''Hi!'' ;)

Image inst4
Enter the root password, please. The root account is for the system administrator who has unlimited access to the m23 server. You should select a password that cannot be guessed easily. It should have at least 10 characters. To use lower and upper case characters plus digits is always a good idea.
As the password will not be shown during typing, you have to reenter it in the following dialog.

Image inst5
The hostname of the server. What a wonderful statement ;)

Image inst6
The IP address that will be used to access the server. The address should be reachable from the clients without the need of a router.

Image inst7

Image inst8

Image inst9
The netmask masks the parts of the IP that belong to the network or to the clients.

Image inst10
The gateway IP is used for requests to IPs that are not connected directly to your network. This is used especially to access the internet.

Image inst11
The DNS server resolves host names and URLs to IP addresses. E.g. ftp.debian.org will be translated to 128.101.80.131. If you don't know a DNS server, you can use the IP 134.245.10.36. This is the DNS server of the university of Kiel.

Image inst12
This is your last chance to check if you have entered all values correctly. Select ''Yes'' if you want to proceed with the installation or ''No'' to correct your settings.

Image inst13
You can choose if you want to use the entire harddisk for m23. This will split your harddisk into two partitions: The first for the Debian operating system and the server software and the second as swap space. If there are more harddisks, only the first one will be used. But you have the possibility to partition your harddisk yourself!

Information about partitioning The entire harddisk of your server will be deleted or you have to partition the harddisk with a programm like parted, fdisk, cfdisk etc. If you would like to do the partitioning by yourself, you have to create two partitions on the first harddisk (hda or sda):

Write down the device names of your created partition, because these values are needed later. E.g. the partitions may be named hda1 for the first partition and hda2 for the second. If you are using extended partitions the device numbers are beginning with hda5. You will be asked for these device names if you select the ''expert'' mode. We recommend saving all data from the server because it will be deleted during partitioning and formating.

Image inst14
Last warning ;)

Image inst15

Image inst16

Image inst17

Image inst18
You can select if you want the bootmanager LILO (LInux LOader) to be installed in the MBR (MasterBootRecord) of the first harddisk. If you do not want it, you have to install a bootmanager on your own. Otherwise, the server will not boot.

Image inst19
The installation is completed ;)

root 2018-01-09